Datalogic DS41-X0 Installation Manual

Datalogic DS41-X0 Installation Manual Manual pdf 23 page image

DS41 DATALOGIC2.8 - Installation2.6.2 Electrical Connections for JBOXThe connection and wiring procedure for JBOX is described as follows:1) Open the junction box by unscrewing the 4 cover screws.2) Pass all System cables through the glands in the junction box housing.3) To connect the power and input/output signals:• Prepare the individual wires of the system cables by stripping theinsulation back approximately 11 mm.• Using a device such as a screwdriver, push down on the orange leverdirectly above the clamp (see Figure 2.8).• Insert the wire into the clamp and release the lever.The wire will now be held in the spring clamp.Figure 2.8 - System cable connections to the junction boxThe wiring used can be solid or stranded but must meet the followingspecifications.Positions 1-4: 24 - 16 AWG 0.2 - 1.5 mm²Positions 5-39: 26 - 20 AWG 0.14 - 0.5 mm²The junction box pinouts are indicated in the following table: