Datalogic Heron D130 Quick Reference

Also see for Heron D130: Quick reference guide Quick reference guide

Contents

Datalogic Heron D130 Quick Reference Manual pdf 15 page image

PEN READER CONFIGURATIONRead the RESTORE DEFAULT code, then read the PENinterface selection code.RESTORE DEFAULTi Pki Pki PkPENi $1#ki $1#ki $1#kDEFAULT VALUESUSB DEFAULT SETTINGSDATA FORMAT: code identifier disabled, no field adjustment,code length not transmitted, character replacement disabled.USB KEYBOARD : USA keyboard, inter-character and inter-code delays disabled, control character emulation =ctrl+shift+key;USB COM : no handshaking, delay disabled, rx timeout 5 sec.,ack/nack disabled, FIFO enabled, serial trigger lock disabled;Default Headers and Terminators for each USB mode:- USB-KBD: no header, terminator = ENTER- USB-KBD-ALT-MODE: no header, terminator = CR- USB-COM: no header, terminator = CR-LF- USB-IBM-TABLE TOP: not applicable- USB-IBM-HAND HELD: not applicableRS232 Standard DEFAULT SETTINGS9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,delay disabled, rx timeout 5 sec., ack/nack disabled, FIFOenabled, serial trigger lock disabled;DATA FORMAT: code identifier disabled, no field adjustment,code length not transmitted, no header, terminator = CR-LF,character replacement disabledRS232 Nixdorf DEFAULT SETTINGS9600 baud, parity odd, 8 data bits, 1 stop bit, handshakinghardware (RTS/CTS), delay disabled, rx timeout 9.9 sec.,ack/nack disabled, FIFO enabled, serial trigger lock disabled;