Data Format Editor IntroductionProduct Reference Guide 5-3bols that represent the command you want to enter. 94 alphanumericcharacters may be entered for each symbology data format.Step 7. Scan Save from the Programming Chart on page B-5 of this manualto save your entries.Other Programming SelectionsClear One Data Format — This deletes one data format for one sym-bology. If you are clearing the primary format, scan 0 from the Program-ming Chart on page B-5 of this manual. If you are clearing an alternateformat, scan 1, 2, or 3, depending on the alternate format you are clear-ing. Scan the Terminal Type and Code I.D. (see Supported Terminals onpage 2-2), and the bar code data length for the specific data format thatyou want to delete. All other formats remain unaffected.Save— from the Programming Chart on page B-5 of this manual. Thisexits, saving any Data Format changes.Discard— from the Programming Chart on page B-5 of this manual. Thisexits without saving any Data Format changes.Data Format Editor CommandsSend CommandsF1 Send all characters followed by “xx” key or function code, starting fromcurrent cursor position. Syntax = F1xx (xx stands for the hex value foran ASCII code, see ASCII Conversion Chart (Code Page 1252) onpage A-4.)F2 Send “nn” characters followed by “xx” key or function code, starting fromcurrent cursor position. Syntax = F2nnxx (nn stands for the numericvalue (00-99) for the number of characters and xx stands for the hexvalue for an ASCII code. See ASCII Conversion Chart (Code Page 1252)on page A-4.)F3 Send up to but not including “ss” character (Search and Send) startingfrom current cursor position, leaving cursor pointing to “ss” character fol-lowed by “xx” key or function code. Syntax = F3ssxx (ss and xx bothstand for the hex values for ASCII codes, see ASCII Conversion Chart(Code Page 1252) on page A-4.)F4 Send “xx” character “nn” times (Insert) leaving cursor in current cursorposition. Syntax = F4xxnn (xx stands for the hex value for an ASCIIcode, see ASCII Conversion Chart (Code Page 1252) on page A-4, andnn is the numeric value (00-99) for the number of times it should be sent.)E9 Send all but the last “nn” characters, starting from the current cursor posi-tion. Syntax = E9nn (nn is the numeric value (00-99) for the number ofcharacters that will not be sent at the end of the message.)
