FCC COMPLIANCEModifications or changes to this equipment without expressed written approval ofDatalogic could void the authority to use the equipment.This device complies with PART 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference which maycause undesired operation.This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.- Consult the dealer or an experienced radio/TV technician for help.POWER SUPPLYDC supply voltage in the range 9 to 30 V DC, intended to be powered by a Class 2power unit with a cable length <3 m.CLASS III Equipment:This equipment is intended for use with UL or CSA Certified, detachable, Class 2Power Supply (SELV provided by Limited Power Source incorporating isolatingtransformer), rated output:9-20 V dc, 0.1-5 A or 20-30 V dc, 0.1-3.3 A! N2468v