Datamax E-Class Mark III Professional Operator's Manual

Also see for E-Class Mark III Professional+: Operator's manual

Contents

Datamax E-Class Mark III Professional Operator's Manual Manual pdf 19 page image

Cha pt e r 2 – Pr int e r Se t up 1 32 .3 .3 Loa ding M e dia w it h t he Pe e l a nd Pr e se nt Opt ionLoad m edia for peeling ( if t he print er is equipped wit h t he opt ion) as follows: When using t he Peel Mechanism do not exceed a print speed of 4 I PS. To ut ilize “ Tear m ode” wit h Peel and Present Opt ion inst alled; m ove t he Peeler Door t o it s open posit ion.1) Load m edia as described in Sect ion 2.3, ( st eps 1- 3) .2) Rem ove about 8 inches ( 200m m ) of labels from t he Media Backing.3) Open t he Peeler Door. Rout e t he Media Backing over t he Plat en Roller and Peel Bar, and t henbehind t he Peel Roller and Peeler Door, as shown below.312 Media Backing Peeler Door Plat en Roller Peel Bar Peel Roller4) Close t he Peeler Door.5) I f using Therm al Transfer m edia ( ribbon) proceed t o Sect ion 2.4 Loading Ribbon. Ot herwise closet he print er’s Cover and press downward unt il lat ched.6) Press t he but t on t o advance t he m edia ( if t he Fault Light is lit , see Sect ion 3.7.)7) The print er will now peel each label and present it t o t he operat or for rem oval. The indicat or lightwill flash orange and t he next label will not feed/ print unt il t he previous label is rem oved. The print er is fact ory set t o use gap m edia. I f using anot her m edia t ype ( for exam ple, cont inuousm edia) , print er set up m ust be reconfigured; see Sect ion 3.4.