Datamax S-Class ST-3210 Operator's Manual

Also see for ST-3210: Quick start guide Programmer's manual Quick reference guide Operator's manual

Contents

Datamax S-Class ST-3210 Operator's Manual Manual pdf 36 page image

26 ST/SV-3210 and ST/SV-33064.2 Start of Print & Cut/Tear AdjustmentIf none of the preset Stock ID parameters meet the needs of yourapplication, then the Start of Print (SOP) and Cut/Tear (C/T)Adjustments can be used to visually set the required positions. To begin:å If on-line, press the PAUSE buttonto place the printer off-line.ç Press and hold (approximately 6seconds) the F3 button until the On-Line Indicator is lit then release.The SOP setup is first, to adjust:ÿ Press the F1 button to increase the current distance (pressingand holding will rapidly move the ticket).ÿ Press the F2 button to decrease the current distance (pressingand holding will rapidly move the ticket).ÿ Press the F3 button to print a ticket showing the new setting.é After completing the SOP adjustment, press and hold (approximately6 seconds) the F3 button until the On-Line Indicator is lit thenrelease.è Next, adjust the Cut/Tear positionusing the F1, F2 and F3 buttons asdescribed above.ê After completing the Cut/Tearadjustment, return the printer tothe off-line mode by pressing andholding the F3 button until the On-Line Indicator is lit then release.ë Press the PAUSE button to return to the on-line mode.˛ Notes: This procedure must be performed in its entirety, even whenno change is desired for one of the settings.After completing the adjustments, always confirm the newsettings by printing several test tickets.If cutting, the cut position on the ticket should occurjust behind the perforation, never in front of theperforation.