Datapath The VisionAV-SDI User Manual
Also see for The VisionAV-SDI: Manual
              | |
DirectShowIf you change the link ordering after installation you must run dplinks.exe. This program will update theexisting input names used by the windows DirectShow interface.To run the dplinks program open the Run by clicking on Start/Run and type dplinks and then press Enter.The program will run, however no notifications are displayed.Firmware UpgradesThe VisionAV-SDI cards allow firmware upgrade to be completed on site rather than returning the card toDatapath. Whenever a firmware upgrade is performed, the J8 Link MUST BE FITTED on theVisionAV-SDI. To perform the upgrade, follow the step-by-step instructions provided by the upgradeapplication.In the unlikely event that something goes wrong during the upgrade process (e.g. System power outage) itis possible to revert to the factory settings by powering down the system, temporarily removing the J8 linkthen powering up the system with the link removed. Once the system has rebooted, replace the J8 linklink (whilst the system is powered up) and restart the firmware upgrade process.It should be noted that the latest driver installation program includes an automatic firmware update, ifrequired. Therefore, prior to installing the application and driver, ensure that J8 link is fitted.Software InstallationThe Vision software (driver and application) is installed by inserting the CD that was shipped with yourcard into your CD ROM drive. The installation process should start automatically.Should the CD fail to autorun use Explorer to browse the CD, locate then double click on install.exefile e.g. d:/install.exe and click on Install Software… and follow the installation wizard instructions asprompted.Regular software updates are available from our website: www.datapath.co.ukAlso available on the Datapath CD:• The Release Notes - The release notes contain the latest information on the VisionAV-SDI• Installation instructions• Release history• Known problems• Troubleshooting• The application Help File - Instructions on how to use the application. The help file is in d:/software/vision.chm. The help file must be located on the local machine to view its content9 |
Related manuals for Datapath The VisionAV-SDI
Datapath VisionAV-SDI Manual
Datapath VisionAV/F User Manual
Datapath The VisionHD4 User Manual
Datapath VisionSC-SDI4 User Manual
Datapath VisionAV Manual
Datapath VisionLC-SDI Manual
Datapath VisionSC-DP2 User Manual
Datapath VisionLC Series User Manual
Datapath VisionRGB-E1 User Manual
Datapath VisionSC-UHD2 User Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine