Datavideo MCU-100P Instruction Manual

Contents

Datavideo MCU-100P Instruction Manual Manual pdf 17 page image

174. Camera Setups4.1 How to copy settings set by MCU-100P from one camera toanotherWhen MCU-100P is used to control more than one camera, it is possible to copy the settings set bythe unit on one camera to another via the Memory Stores functions of the unit.Follow the following procedure to copy the settings set by the unit on camera to another.1. Select the camera from which you want to copy the settings via the CAM 1 to CAM 4buttons.2. Press the LOAD SAVE button to start the copy process. The LOAD SAVE button will be backlit orange and blinking.3. Whilst the LOAD SAVE button is back lit orange and blinking select the camera to which youwant to copy the settings via the CAM 1 to CAM 4 buttons.4. When the LOAD SAVE button is back lit green the copy process is then completed.Note: This process does not work if either the selected source or destination camera is notconnected or is not powered on.4.2 How to store / recall settings from internal memory MU-1, MU-2or MU-3The MCU-100P has dedicated internal memory to store the settings set by the unit on fourcameras. This internal memory can be accessed using the Memory Store functions.Internally, the unit has three memory blocks indicated by the Memory Stores MU-1, MU-2 andMU-3. Each of these blocks is divided into four segments, one segment for each camera. These areused to store the settings for each camera accordingly.Use this procedure to store the settings on a camera to the MCU-100P unit’s internal memory.1. Select the camera from which you want to copy the settings via the CAM 1 to CAM 4buttons.2. Press the LOAD SAVE button to start the copy process. The LOAD SAVE and the selectedcamera button will be back lit orange and blinking.3. Whilst these buttons are back lit orange and blinking select the memory block, MU-1, MU-2 or MU-3 button, to which you want to copy the settings.4. When the MU-1, MU-2 or MU-3 button is back lit green and the copy process is thencompleted.Use this procedure to recall a previously saved setting on the MU-1, MU-2 or MU-3 button to acamera.1. Select the camera to which you want to copy the stored settings via the CAM 1 to CAM 4buttons.2. Select the memory block from which you want to copy the settings via the MU-1, MU-2 orMU-3 button.3. Press the LOAD SAVE button to start the copy process. The LOAD SAVE and the selectedcamera button will be back lit orange and blinking.4. These buttons will be back lit green when copy process is completed.