DeLonghi CERAMIC FAN HEATER Instructions Manual

Also see for CERAMIC FAN HEATER: Instructions Instructions Instructions Instructions Instructions

ELECTRICAL CONNECTIONS- Before plugging into the mains, make sure the voltage of your mains supply corresponds tothe V value indicated on the appliance and that the socket and power line are appropriatefor the load required.- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EEC ON RADIO INTERFERENCESUPPRESSION.INSTALLATIONThe appliance can be used on any horizontal surface. Do not use the same socket for more than oneappliance.ASSEMBLING THE APPLIANCE1. Fit the base of the appliance to the body by inserting the pins in their housings (see figure 1).2. Turn the appliance upside down and fix the base to the body of the appliance with the screws provided(see figure 2).3. Pass the power cable through the opening in the base (see figure 3).OPERATION AND USE1. Make sure the appliance is off before plugging into the mains.2. To turn the appliance on, the ON/OFF switch (L) at the back of the appliance must be in the Iposition.The appliance emits a beep. The light (H) also comes on and remains lit while power to theappliance is on.3. The appliance is in stand-by mode and "- -" is displayed.4. Press the button (A) to turn the appliance on. It will start heating with the current settings.5. Press the MODE button (E) to select one of the following modes:Heating ( ), Fan ( ), Freeze protection ( ).5.1 Heating ( )In this mode, the required temperature can be set by pressing buttons + and - (B) and selec-ting one of the power levels, MIN, MAX or AUTO, by pressing button D ( ).MIN power level: The appliance operates at minimum power, reducing noise levels andenergy consumption to a minimum.MAX power level: The appliance operates at maximum power to heat the room rapidly.AUTO power level: The appliance determines the power automatically according to roomconditions.5.2 Fan ( )In this mode, only the fan is active and the appliance does not heat the room. Press thepower selector button (D) ( ) to select the required fan speed, MIN or MAX.5.3 Freeze protection ( )In this mode, the appliance keeps the room at a temperature of 7°C to avoid freezing.6. If you want the appliance to distribute the air flow over a wider area, press the swing button (C)( ).The appliance will swing from right to left.To stop the appliance in the desired position, simply press button (C) again.7. To turn the appliance off, press button A and place the switch (L) on the back in the 0 position.NOTE: The display can show the temperature in both °F and °C. To select, press and hold the + keyfor at least 5 seconds, then release.4DESCRIPTIONA ON/STAND-BY buttonB +/- regulation buttonsC Swing buttonD Power selector buttonE MODE button (selects the operating mode)F Timer buttonG Remote control receiverH Indicator lightI Tip over deviceJ GrilleK FilterL ON/OFF switchGB