33NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug fromthe mains, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door andreplace the infuser.15.3 Cleaning the milk containerProceed as follows:• Remove the milk spout (fig. 32) and intake tube.• Remove the froth regulator by pulling it outwards.• Wash the container and lid in a dishwasher or inhot soapy water. Make sure there are no milk resi-dues inside the two holes in the lid of the milk con-tainer indicated by the arrows in the figure.• Put the froth regulator, intake tube and milk spoutback in the milk container lid.16 CHANGING AND SETTING THE MENU PARAMETERSAfter pressing the button, when the appliance is ready, you can use the internal menu to modify the fol-lowing parameters and functions:• Clock• Auto-start time.• Descaling process• Coffee temperature• Length of time the appliance remains on• Water hardness• Factory default values• Washing process16.1 Setting the clockTo set the clock, proceed as follows:• Press the button (the light over the button comes on) then press the button repeatedly untilthe appliance displays:CLOCK 00:00• Press the button to set the clock. (If you hold the button down, the time is changedrapidly).• Press the button to confirm the value;• Press the button to exit programming mode or to change other parameters.16.2 Setting auto-start timeThis enables the time the appliance will come on automatically and be ready for use to be programmed.• Make sure the clock on the appliance is set as described above.• Press the button then press the button repeatedly until the appliance displays:START TIME 00:00frothregulator