DeLonghi DE91PYROS Installation And Service Instructions Use And Care Instructions

DeLonghi DE91PYROS Installation And Service Instructions Use And Care Instructions Manual pdf 6 page image

INSTALLATIONCAUTION: This appliance must be installed in accordance with these installationinstructions. This appliance shall only be serviced by authorized personnel. This appliance is to be installed only by an authorised person. Incorrect installation, for which the manufacturer accepts no responsibil-ity, may cause personal injury of damage. Always disconnect the oven from mains power supply before carryingout any maintenance operations or repairs.N.B. • The connection of the appliance to earth is mandatory.• For connection to the mains, do not use adapters, reducers orbranching devices as they can cause overheating and burning.If the installation requires alterations to the domestic electrical system call a qualifiedelectrician. He should also check that the domestic electrical system is suitable for thepower drawn by the appliance.ELECTRICAL REQUIREMENTS Connection to the mains must be carried out by qualified personnel inaccordance with current regulations. The appliance must be connected to the mains checking that the voltagecorresponds to the value given in the rating plate and that the electrical cablesections can withstand the load specified on the plate. A suitable isolating switch providing full disconnection from the mains powersupply (under overvoltage category III conditions) must be incorporated in thepermanent wiring, mounted and positioned to comply with the local wiringrules and regulations.The isolating switch must be of an approved type and provide a 3 mm air gapcontact separation in all poles (or in all active [phase] conductors if the localwiring rules allow for this variation of the requirements). The power supply cable must not touch the hot parts and must be positionedso that it does not exceed 75°C at any point. Once the appliance has been installed, the switch or socket must always beaccessible. If the supply cord is damaged it must be replaced by the manufactureror its Service Agent or a similarly qualified person in order to avoid ahazard.6