DeLonghi DEFSGG 24 SS Installation Instructions Manual

Also see for DEFSGG 24 SS: Operating instructions

Contents

DeLonghi DEFSGG 24 SS Installation Instructions Manual Manual pdf 5 page image

5GENERAL INFORMATION1. Installation must conform with local codes or, in theabsence of local codes, with the National Fuel Gas Code,ANSI Z223.1-Latest Edition.2. Installation in manufactured (mobile) home: installationmust conform with the Manufactured Home Constructionand Safety Standard, Title 24 CFR, Part 3280 [formerlythe Federal Standard for Mobile Home Construction andSafety, Title 24, HUD (Part 280)] or, when such standardis not applicable, the Standard for Manufactured HomeInstallations, ANSI/NCSBCS A225.1, or with local codeswhere applicable.3. Installation in Recreational Park Trailers: installation mustconforms with state or other codes or, in the absence ofsuch codes, with the Standard for Recreational ParkTrailers, ANSI A119.5.4. WARNING!!This appliance shall not be used for space heating. Thisinformation is based on safety considerations.5. AlI openings in the wall behind the appliance and in the floorunder the appliance shall be sealed.6. Keep appliance area clear and free from combustiblematerials, gasoline, and other flammable vapors.7. Do not obstruct the flow of combustion and ventilation air.8. Disconnect the electrical supply to the appliance beforeservicing.9. When removing appliance for cleaning and/or service;A. Shut off gas at main supply.B. Disconnect AC power supply.C. Disconnect gas line to the inlet pipe.D. Carefully remove the range by pulling outward.CAUTION: Range is heavy; use care in handling.10. Electrical RequirementElectrical installation should comply with national and localcodes.11. Air Supply and VentilationThe installer must refers to local/national codes.12. Gas Manifold PressureNatural gas - 4.0” W.C.P.LP/Propane - 11.0” W.C.P.13. The misuse of oven door (e.g. stepping, sitting, or leaningon them) can result in potential hazards and/or injuries.14. When installing or removing the range for service, a rollinglift jack should be used. Do not push against any of theedges of the range in an attempt to slide it into or out ofthe installation. Pushing or pulling a range (rather than usinga lift jack) also increases the possibility of bending the legspindles or the internal coupling connectors.WARNING!!ELECTRICAL GROUNDING INSTRUCTIONSThe range must be electrically grounded in accordancewith local codes or, in the absence of local codes, with theNational Electrical Code, ANSI/NFPA No. 70-latest edition.Installation should be made by a Iicensed electrician.FOR PERSONAL SAFETY, THIS APPLIANCE MUST BEPROPERLY GROUNDED.If an external electrical source is utilized, the installation mustbe electrically grounded in accordance with local codes or, inthe absence of local codes, with the national Electrical Code,ANSI/NFPA 70.This appliance is equipped with a three-prong grounding plugfor your protection against shock hazard and should beplugged directly into a properly grounded socket.Do not under any circumstances cut or remove the third(ground) prong from the power plug.REPLACEMENT PARTSOnly authorized replacement parts may be used in performingservice on the range. Replacement parts are available fromfactory authorized parts distributors. Contact the nearest partsdistributor in your area.