EN1444 / SPECIAL MESSAGES, DIFFICULTIESWarningIn the event that there is a break, crack or opening--even minor--in the vitroceramicglass, immediately disconnect your appliance to avoid the risk of electric shock.Contact the After-Sales Service Department.YOU OBSERVE THAT:POSSIBLE CAUSES: WHAT SHOULD YOU DO:An indicator light appears.Your installation blows a fuse.Only one side works.The hob produces an odourduring the first cooking ses-sions.Working normally.The electrical hook-up of yourhob is incorrect.New appliance.Nothing.Verify the connections.See the "Hook-Up" sec-tion.Operate each cookingzone for 30 minutes with asaucepan full of water.The hob stops working and itemits a beep approximatelyevery 10 seconds and a or"F7" is displayed.A series of small or "F7" isdisplayed.After turning on a heating zone,the indicator lights on thecontrol panel continue to flash.The saucepans make noiseduring cooking.Your hob makes a clickingsound during cooking.The fan continues to function afew minutes after your hob isturned off.There was an overflow or anobject is in contact with thecontrol panel.The electronic boards heatedup.The cookware used is not sui-table for induction or is lessthan 12 cm in diameter (10 cmfor the 16-cm cooking zone).This is normal with some typesof cookware. This is caused bythe transfer of energy from thehob to the cookware.Cooling of the electronic com-ponents.Working normally.Clean the hob or removethe object, then begincooking again.See "Built-In" section.See section on cookwarefor induction.Nothing. There is no risk,neither to your hob nor toyour cookware.Nothing.•During operation•During initial useYOU OBSERVE THAT:POSSIBLE CAUSES: WHAT SHOULD YOU DO:The hob is not working and theindicator lights on the controlpanel are not on.The table is not working andanother message is displayed.The hob does not function, theinformation is displayed.The appliance is not receivingelectricity. The electrical sup-ply is defective or the hook-upis incorrect.The electronic board is func-tioning poorly.The hob is locked.Inspect the electrical cir-cuit breaker and fuses.Call the After-SalesService Department.See chapter on using thechild safety system.•When powering onYOU OBSERVE THAT:POSSIBLE CAUSES: WHAT SHOULD YOU DO: