DeLonghi Dinamica ECAM35020W Manual

Contents

DeLonghi Dinamica ECAM35020W Manual Manual pdf 6 page image

115. Press the OK icon (B15) to confirm (or ESC(B14) to exit without making the change). The lights go off.The auto-off time is now programmed.9. ENERGY SAVINGUse this function to enable or disable energy saving. This modeis active by default, reducing energy consumption while the ma-chine is on in compliance with current European regulations. Tochange the setting, proceed as follows:1. With the machine off (standby), but the main switchpressed (A6) (fig. 1);2. Press and hold the icon (B9) until the icons on thetouch screen (B) come on.3. Press the icon (B13);4. Press the icon again to enable/disable the function:• function enabled• function disabled5. Press the OK icon (B15) to confirm (or ESC(B14) to exit without making the change). The lights go off.The energy saving setting is now programmed.Please note:• When in energy saving mode, a few seconds may elapsebefore the first coffee is delivered as the machine mustheat up again.10. BEEPThis function enables or disables the beep. Proceed as follows:1. With the machine off (standby), but the main switchpressed (fig. 1);2. Press and hold the icon (B9) until the lights on thetouch screen (B) come on.3. Press the icon to enable/disable the function:• function enabled• function disabled4. Press the OK icon (B15) to confirm (or ESC(B14) to exit without making the change). The lights go off.The beep is now programmed.11. DEFAULT VALUES (RESET)This function resets all settings (temperature, auto-off, water hard-ness, energy saving and all quantity settings are reset to the defaultvalues).1. With the machine off (standby), but the main switchpressed (fig. 1);2. Press and hold the icon (B9) until the lights on thetouch screen (B) come on.3. Press the icon (B12). The bean icons (B7) on the touchscreen flash;4. Press the OK icon (B15) to reset the default values(or ESC (B14) to exit without making the change).The lights go off.The settings and quantities of the beverages have been reset tothe default values.12. RINSINGUse this function to deliver hot water from the coffee spouts(A19) to clean and heat the machine’s internal circuit.Place a container with a minimum capacity of 3.38 floz/100mlunder the coffee and hot water spouts.Important! Danger of burns.Do not leave the machine unattended while hot water is beingdelivered.1) To activate the function, press OK (B15);2) After a few seconds, hot water is delivered from the coffeespouts, cleaning and heating the machine’s internal circuit.3) To interrupt the function manually, press OK again.Please note:• If the machine is not used for more than 3-4 days, whenswitched on again, we strongly recommend performing2/3 rinses before use;• After cleaning it is normal to have water collected in thecoffee ground container (A11).13. MAKING COFFEE13.1 Adjusting the coffee grinderThe coffee grinder is set by default to prepare coffee correctlyand should not require regulating initially.However, if after making the first few coffees you find that thecoffee is either too weak and not creamy enough or delivery istoo slow (a drop at a time), this can be corrected by calibratingthe coffee grinding using the adjusting dial (A5) (fig. 8).Please note:The grinding adjustment dial must only be turned when thecoffee grinder is in operation.If the coffee is delivered too slowly or notat all, turn one click clockwise towards 7.For fuller bodied creamier coffee, turnone click anticlockwise towards 1 (do notturn more than one click at a time other-wise the coffee could be delivered a dropat a time).