6enMaintenance and service/TroubleshootingAt the end of the set time the appliance switches on-standbyautomatically. To go back to operating without the timer,press the timer button twice.The timer symbol disappears from the display.note: the time is settable from 0.5 to 24 hours.changing of the temperature scaleThe display can show the temperature in both °f (fahrenheit)and °C (Celsius). To select the desired temperature scale,when the unit is in standby position, press and hold the "+"and "eCo" keys for at least 10 seconds, then release.The change of scale will be indicated by two short beeps.AlarmsThe appliance has a diagnostic system that makes it possibleto signal malfunctions.In case of problems, the display will show an alarm message:(Product failure)With this alarm the appliance does notoperate. Check if the appliance is correctlypositioned. If the problem persists, contactthe nearest Customer experience.(High temperature)When the product’s internal temperatureis too high, the heating power willprogressively and automatically bereduced. The display shows for twoseconds, on and off. To remove the causeof this alarm check that the unit is notcovered or obstructed.safety deviceA safety device shuts the radiator down in the case ofoverheating. To start the radiator up again, contact Customerexperience. See enclosed guarantee leaflet.MAInTEnAncE AnD sERVIcEBefore performing any operations on the appliance, alwaysunplug from the mains socket and leave to cool.Wipe the radiator with a soft damp cloth without usingdetergents or abrasives. If the radiator is not to be used fora long period of time, wrap the cable around the cable tidyand store the appliance in a dry place. This appliance hasbeen made to last many years without problems. In theevent of malfunction or doubt, do not try and repair on yourown. There would be the danger of fire or electric shock.Please refer to the enclosed guarantee leaflet for service andassistance details.TRouBLEsHooTIngpRoBLEM cAusE soLuTIonThe appliance doesn'twork- Be sure it is plugged in and that the electricaloutlet is working.- Check for any obstruction.- The temperature may be set too low.- The Key lock may be activated.- Plug into the power outlet.- remove the obstruction and let theappliance cool down. If the appliancedoesn't work please contact Customerexperience.- Set the temperature to a higher position.- See the section "Key lock".