WATER FILTERPlease note! The filter lasts about two months if the appliance is used normally. If the coffee maker isleft unused with the filter installed, it will last a maximum of three weeks.11A C D EBInstalling the filter1. Remove the filter from thepackaging.2. Turn the date indicator disk(A) until the next 2 months ofuse are displayed.3. To activate the filter, put itunder tap water until wateroverflows the side openingsfor more than 1 minute (B).4. Remove the tank from theappliance and fill with water.5. Insert the filter in the watertank and immerse it completelyfor ten or so seconds, slopingit to enable the air bubbles toescape (C).6. Insert the filter in the filterhousing (D) and press as far as it will go.7. Close the tank with the lid (E), then placethe tank in the machine.8. Place a container with aminimum capacity of 16.91 oz./ 500 ml under the hot water/steam spout.9. Turn the hot water/steam dialin position I to deliver hot water.10. Let the appliance deliver hotwater, until the delivery flows reg-ulary (min 16.91 fl. oz/500ml),then turn the dial in position 0.Please note:It may happen that a single hotwater is not sufficient to install thefilter: the lights come on.In this case, repeat the installingoperation from step 8. The new filteris active and you can now use thecoffee maker.