DeLonghi ETAM29.66X Instructions For Use Manual

Contents

15MAKING CAPPUCCINOS AND MILK BASED COFFEESPlease note!• To avoid producing milk with poor froth or large bubbles,always clean the milk container lid and hot water nozzle asdescribed in the section “Cleaning the milk container” onpages 15 and 18.Filling and attaching the milk container1. Remove the lid (fig. 17);2. Fill the milk container with a sufficient quantity of milk,not exceeding the MAX level marked on the handle (fig.18). Each mark on the side of the container corresponds toabout 100 ml of milk.Please note!• For a denser more even froth, you must use skimmed orpartially skimmed milk at refrigerator temperature (about5°C).• If “Energy saving” mode is enabled, you may have to wait afew seconds before the drink is delivered.3. Make sure the milk intake tube is correctly inserted in thebottom of the milk container lid (fig. 19).4. Place the lid back on the milk container.5. Remove the hot water spout (C3) (fig. 20).6. Attach the milk container to the connection nozzle andpush as far as it will go (fig. 21). The machine emits a beep(if the beep function is enabled).7. Place a sufficiently large cup under the coffee spoutsand the frothed milk spout. Adjust the length of the milkspout (fig. 22). To move it nearer the cup, simply pull itdownwards.8. Follow the Instruction for use below for each function.Adjusting the amount of frothTurn the froth adjustment dial (D2) to adjust the amount of frothon the milk delivered while making cappuccino and milk basedcoffees.DialpositionDescription Recommended for...No froth CAFFELATTE /MILK (hot milk)Min. froth LATTE MACCHIATO/FLAT WHITEMax. froth CAPPUCCINO /MILK (frothed milk)Making cappuccinoThe icon (B9) on the control panel enables CAPPUCCINO to beprepared automatically. Proceed as follows:1. Fill the milk container and attach it as described above.2. Turn the froth adjustment dial on the milk container lid tothe position corresponding to the required froth (see previ-ous table).3. Press the CAPPUCCINO icon (B9). The name of thedrink selected is displayed together with a progress barwhich gradually fills as preparation progresses.4. After a few seconds, frothed milk is delivered from the milkspout into the cup below. Then the machine automaticallymakes the coffee after delivering the milk.Preparing “MILK MENU” drinksBesides the drinks described above, the appliance automaticallyprepares CAFFELATTE, MACCHIATO, FLAT WHITE and MILK.To prepare one of these drinks, simply proceed as follows:1. Fill the milk container and attach it as described above.2. Turn the froth adjustment dial on the milk container lid tothe position corresponding to the required froth.3. Press the MILK MENU icon (B8).4. Press or (fig. 5) until the required drink is dis-played (CAFFELATTE, MACCHIATO, FLAT WHITE, MILK).5. Press the icon (fig. 6) to start delivery.6. After a few seconds, frothed milk is delivered from the milkspout into the cup below. For drinks with coffee, the ma-chine automatically makes the coffee after delivering themilk.Please note: general indications when preparing allmilk based drinks• If you want to interrupt preparation during delivery, pressthe corresponding icon.• At the end of delivery, to increase the quantity of milk orcoffee in the cup, just press and hold (within 3 seconds) theicon corresponding to the drink being made.• Do not leave the milk container out of the refrigerator forlong periods. The warmer the milk (5°C is ideal), the poorerthe quality of froth produced.Cleaning the milk container after useImportant! Danger of burnsWhen cleaning the internal tubes of the milk container, a littlehot water and steam leak out of the frothed milk spout. Avoidcontact with splashes of water.“SET DIAL TO CLEAN” flashes on the display each time you use amilk function. To eliminate all milk residues, proceed as follows:1. Leave the milk container in the machine (you do not needto empty it);