DeLonghi MULTIFUNCTION BUILT-IN OVENS WITH SIDE OPENING DOOR Installation And Service Instructions Use And Care Instructions

DeLonghi MULTIFUNCTION BUILT-IN OVENS WITH SIDE OPENING DOOR Installation And Service Instructions Use And Care Instructions Manual pdf 5 page image

5INSTALLATIONCAUTION: This appliance must be installed in accordance with these installationinstructions. This appliance shall only be serviced by authorized personnel. This appliance is to be installed only by an authorised person. Incorrect installation, for which the manufacturer accepts no responsibil-ity, may cause personal injury of damage. Always disconnect the oven from mains power supply before carryingout any maintenance operations or repairs.N.B. • The connection of the appliance to earth is mandatory.• For connection to the mains, do not use adapters, reducers orbranching devices as they can cause overheating and burning.If the installation requires alterations to the domestic electrical system call a qualifiedelectrician. He should also check that the socket cable section is suitable for the powerdrawn by the appliance.ELECTRICAL REQUIREMENTS The oven is supplied without a power supply plug and therefore if you arenot connecting directly to the mains, a standardized plug suitable for theload must be fitted. Connection to the mains must be carried out by qualified personnel inaccordance with current regulations. The appliance must be connected to the mains checking that the voltagecorresponds to the value given in the rating plate and that the electricalcable sections can withstand the load specified on the plate. The plug must be connected to an earthed socket in compliance with safetystandards. The appliance must be connected directly to the mains placing a two poleswitch with minimum opening between the contacts of 3 mm between theappliance and the mains. The power supply cable must not touch the hot parts and must bepositioned so that it does not exceed 75°C at any point. Once the appliance has been installed, the switch or socket must always beaccessible. If the supply cord is damaged it must be replaced by themanufacturer or its Service Agent or a similarly qualified person inorder to avoid a hazard.