DeLonghi NESPRESSO Gran Lattissima EN650 User Manual

Also see for Nespresso Gran Lattissima EN650: User manual

31ENTroubleshootingNo light indicator. - Check the mains, plug, voltage, and fuse. In case of problems, call Nespresso.No coffee, no water. - Water tank is empty. Fill water tank.- Descale if necessary; refer to section "Descaling".Coffee comes out very slowly. - Flow speed depends on the coffee variety.- Descale if necessary; refer to section "Descaling".No coffee, just water runs out (despite inserted capsule). - In case of problems, send appliance to repair or call Nespresso.Coffee is not hot enough. - Preheat cup.- Descale if necessary; refer to section "Descaling".Capsule area is leaking (water in capsule container). - Position capsule correctly. If leakages occur, call Nespresso.Irregular blinking. - Send appliance to repair or call Nespresso.All buttons blink simultaneously for 10 seconds and then machine switches offautomatically. - Error alarm, machine needs repair. Send appliance to repair or call Nespresso.All coffee buttons blinking fast 3 times and then machine goes back in ready mode. - Water tank is empty.Descaling and clean alerts blink.- Machine is in menu mode, press simultaneously hot milk and flat white buttons for 3 seconds to exit menu mode or wait 30seconds to exit automatically.- Descaling has not properly completed. Repeat the descaling cycle.Descaling alert shines orange. - Machine triggers descaling alert according beverages consumption usage. Descale machine. Refer to section "Descaling".Descaling alert blinks orange and flat white button steady light. - Machine is in descaling mode. Press flat white button to start descaling process.Clean alert shines orange. - Disassemble the Rapid Cappuccino System and clean all components in the upper side of your dishwasher. In case a dishwasher isnot available, refer to section "Hand washing of Rapid Cappuccino System " .All coffee buttons and all milk recipe buttons flash alternatively.- Machine overheat, wait until machine cools down.- Appliance will be blocked for approximately 10 minutes after emptying procedure (refer to section "Emptying the system before aperiod of non-use, for frost protection or before a repair").Lever cannot be closed completely. - Empty capsule container. Make sure that no capsule is blocked inside the capsule container.Quality of Milk froth is not up to standard.- Use skimmed or semi-skimmed cow milk at refrigerator temperature (about 4° C).- Milk froth regulator knob is on position. Turn it to (Froth) position.- Rinse after each milk preparations (see section "Hand Washing of Rapid Cappuccino System").- Descale the machine (refer to section "Descaling").- Do not use frozen milk.- Ensure the air aspiration part is clean. Refer to the section "Hand washing of Rapid Cappuccino System".- Ensure all the components of the Rapid Cappuccino System are well assembled.I cannot enter Menu mode.- Be sure to remove the milk jug.- Be sure to press simultaneously hot milk and flat white buttons for 3 seconds.- Be sure to remove descaling pipe.Milk jug cannot be dismantled. - Press the buttons on the sides of the milk jug to remove the parts.- Refer to section "Assembling / Disassembling of Rapid Cappuccino System".Turn off the machine. - Press the on-standby button (The machine is on stand-by - consumption 0.22 Wh).Milk jug is inserted but the milk buttons are not enabled - The milk froth regulator knob is on (Clean) position. Turn it to (Froth) position.

/ 32

Related manuals for DeLonghi Nespresso Gran Lattissima EN650