DeLonghi PAC 260 Use And Maintenance Manual

Contents

DeLonghi PAC 260 Use And Maintenance Manual Manual pdf 10 page image

10ON/OFF buttonON/OFF pilot light“Alarm” pilot lightTimer ON/OFFpilot lightSelecting fanspeed buttonTimer ON/OFFbuttonThermostatTimer notchesSETTING THE TIMERThe programmer/timer, like all clocks, must beset to the exact time. If for example it is 4.00p.m., turn the dial in a clockwise direction (fol-lowing the direction of the arrow) until the num-ber 4 is lined up with the arrow pointer (thearrows indicates 4:00 p.m. approximately).Note:Never turn the dial in an anti-clockwisedirection!The timer is in effect, an electric clock and worksonly if the plug is connected to the power sup-ply. Whenever the plug is disconnected or thereis a power failure, the programmer stops (theclock is then “slow”) and must be re-set.The unit can be used in either programmed ornon-programmed mode.PROGRAMMED MODE1) Release B timer button2) Set the operating times by pushing out thenotches on the dial corresponding to theperiod required (each notch represents 15mins.).3) Check that the timer indicates the correcttime (see instructions on setting).4) Select the desired function as shown in thechart overleaf.The unit will now switch on and off each dayat the selected times.Note: To override the programmed operatingtimes, simply press the ON/OFF key.NON-PROGRAMMED MODE1) B TIMER button must be pressed2) Select the desired function as shown in thechart on the following page.arrow pointerOperating timeNote: For technical reasons, the temperature is not expressed in degrees but by a line increasing inthickness. We therefore recommend that when starting up the appliance, the thermostat beturned to maximum (thick green line = maximum cold). When the desired temperature hasbeen reached, turn the thermostat slowly away from the maximum cooling position until theappliance switches off. Leave the thermostat in this position. The air-conditioner is now pro-grammed to maintain the exact temperature at all times.After switching the appliance off, wait at least 3 min. before switching on again.eg. from 9 to 11 a.m.C o n t r o l p a n e lGB 19-05-2003 16:32 Pagina 10