DeLonghi Pinguino K900 Instructions For Use Manual

Contents

DeLonghi Pinguino K900 Instructions For Use Manual Manual pdf 8 page image

11ENGLISHO p e r a t i o nSWITCHING THE APPLIANCE ONConnect the appliance to the mains supply.On the display two lines will appear indicating Stand-by modePress the ON/OFF button (A) and then the MODE button until therelevant function indicator appears viz.:Indicator C : air-conditioningIndicator D : dehumidifyingIndicator E : ventilationAIR-CONDITIONING FUNCTIONThis function is ideal in hot, humid weather conditions when theatmosphere requires to be cooled and dehumidified.To ensure proper function of the appliance, after selecting the air-conditioning function, press buttons + (F) or – (G) until the desiredtemperature appears on the display.The temperatures most suited to the atmosphere in summer varybetween 75 °Fand 80°F. We do not advise selection of tempera-tures much lower than those outside.Select fan speed by pressing the “FAN” button (Q) until the fanspeed indicator appears:MAX (P): if you want the maximum power of the air-conditioner toreach the desired temperature as quickly as possible.MIN (O): if you want to reduce the level of noise and still maintaina good level of comfort.SILENT (N):when minimum noise is required,AUTO (M):if you prefer the appliance to select the fan speed forthe temperature selected on the display panel.DEHUMIDIFYING FUNCTIONThis function is ideal for reducing humidity in the atmosphere whileavoiding increases or decreases in temperature (in between sea-sons, damp places, wet spells of weather).When you select the dehumidifying function, the letters “ ” willappear on the display.The water is collected in the tank at the rear of the appliance.When the tank is full, the appliance will stop working and thedisplay will show the letters “ ” (Full Tank); the tank must then beemptied. When it is re-inserted, the appliance will re-start auto-matically. N.B. remove the air exhaust hose (14).In the air-conditioning function, the unit employs an exclusive con-densation recycling system to dispose of excess moisture. In normalconditions, condensation is disposed of automatically. When thehumidity is particularly high, an excess of condensation may built upin the TANK (9). When this happens, the display will show the letters“ “ (Full Tank); indicating that the TANK should be emptied. Whe-never conditions of high humidity make the problem recurrent, youmay discharge the excess water directly into a drain, using the rub-ber tube supplied. The tube should be inserted into the hole provi-ded, after having removed the rubber stopper. (see figure below).Make sure the TANK is put back correctly otherwise the display willcontinue to show the letters “ ”GB 8-07-2003 15:32 Pagina 11