DeLonghi Pinguino PAC CT110 Instructions For Use Manual

Contents

DeLonghi Pinguino PAC CT110 Instructions For Use Manual Manual pdf 7 page image

10Using the remote controlMODELS WITH REMOTE CONTROL• Point the remote control at the receiver onthe air conditioner. The remote controlmust be no more than 23 ft (7 metres)away from the appliance (without obsta-cles between the remote control and thereceiver)• The remote control must be handled withextreme care. Do not drop it or expose itto direct sunlight or sources of heat.DESCRIPTION OF THE REMOTE CONTROL16) Fan button17) ON/STAND-BY button18) Mode button19) Timer button20) DisplayReplacing the batteries• Remove the cover on the rear of theremote control;• Replace the old batteries with two newR03 “AAA” 1.5V batteries, inserting themcorrectly (see the instructions inside thebattery compartment);• Replace the cover.2016171918If the remote control unit is replaced or discarded, the batteries must be removed and disposedof in accordance with current legislation as they are harmful to the environment. Do not mix oldand new batteries.Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Do notdispose of batterias in fire. Batteries may explode or leak.• Note: This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation.• This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio com-munications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.- Consult the dealer or an experienced radio/TV technician for help.Changes or modifications not expressly approved by the party responsible for compliancecould void the user's authority to operate the equipment.• This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference, and (2) this device mustaccept any interference received, including interference that may cause undesired opera-tion.MAX 23 ftMAX 7 metres