Dean SM20 Installation & Operation Manual

Also see for SM40: Installation & operation manual

Dean SM20 Installation & Operation Manual Manual pdf 14 page image

DEAN MILLIVOLT GAS FRYERS (CE)CHAPTER 3: INSTALLATION INSTRUCTIONS3-13.1 Installing the FryerA. Initial Installation: If installed with legs, do not push against the fryer’s side to adjust itsposition. Use a pallet or lift jack to lift the fryer slightly and place it where it is to be installed.B. Relocating the Fryer: If relocating a fryer installed with legs, remove all weight from each legbefore moving.Note: If a leg becomes damaged during movement, contact your service agent for immediaterepair/replacement.CAUTIONFryers may not function properly if curb mounted.DANGERThis fryer may tip and cause personal injury if not secured correctly in a stationaryposition. Drain all oil/shortening from fryer before moving. Hot oil will splash andcause severe burns upon contact.3.2 Leg and Caster InstallationA. General1. Install legs and rear rigid casters near where the fryer is to be used, as neither are secure forlong transit. Unit cannot be curb mounted and must be equipped with the legs and castersprovided.2. When positioning the fryer, gently lower the fryer into position to prevent undue strain tothe legs and internal mounting hardware. Use a pallet or lift jack to lift and position thefryer if possible. Tilting the fryer may damage the legs.3. The rigid casters must be installed on the fryer rear channel assembly only.4. Proceed to Step 3.3, Leveling the Fryer, after legs and rear rigid casters are installed toensure the fryer is level before using.