Dedicated Micros SD Range Installation And Operation Manual

Also see for SD Range: Installation and operation guide Installation and operation guide Quick start guide

Dedicated Micros SD Range Installation And Operation Manual Manual pdf 37 page image

Dedicated Micros ©2007 SD RangeGlobal AlarmsDisplay mode A monitor can be configured to switch to display mode on alarmactivation.Post Alarm Post alarm defines what happens when an alarm conditionhas completed. Select Last to leave the last alarmed cameradisplayed. Select Revert to return the display to its state prior tothe alarm being raised.Camera fail A relay can be assigned to activate if a camera fail is registeredby the DVR. This is hard defined as Relay 3.Camera fail sounder The on board sounder can be set to activate if a camera fail isregistered by the DVR.Pre alarm (secs) This is the period of time, prior to the alarm start that will beincluded along with the alarm recording for archive. These imageswill be protected from being overwritten with the alarm imagesThe unit places a ‘marker’ in the regular recording that acts as thestart of the pre-alarm recording, the number of images availablewill be dependant on the pre-alarm time set.Alarm entry/exit (secs) The alarm entry/exit timer is the time interval between an entryinitiator being activated and alarms being triggered, or the alarmkeyswitch being tripped and the exit initiator being activated. Thistimer will allow a key holder sufficient time to enter or exit thepremises without triggering an alarm. This is set in seconds.Alarms (Red) This button will navigate back to the main Alarms page.Cancel (Purple) Settings are automatically saved when the page is closed. Usethis button to cancel any changes before navigating away fromthe page.Save To ‘manually’ save changes whilst in a menu page, select theSave button.