Tools required: 4mm (or 5/32") Allen Wrench (also called Hex Key driver)Parts required: Polished Granite Base, Cable Clip for AC Cord,four allen head bolts, eights plastic washersInstructions:1. Carefully lay the Mythos ST on its side. Lift the base of the speaker about sixinches and support it with a soft padded object, such as a pillow. Do NOTsupport the speaker with a hard object, as you might dent or scratch thealuminum finish.2. Place one plastic washer on each bolt.3. Insert the bolts into the granite base from the same side that the black feet areattached to.4. Place another plastic washer on each bolt so the washer is against the granite.5. Finger tighten all four bolts into the threaded holes on the bottom of theMythos. If this has been done correctly, washers will be between the metalsurface of the Mythos ST, the granite, and the heads of the bolts.6. GENTLY tighten each bolt with the allen head wrench. Do NOT overtightenor you may crack the granite.Base Installation InstructionsSafety Precautions Specific to Mythos STThe cautionary marking label is located on the bottom of the speaker,visible through an opening in the granite base.Power Supply1. The fuse and power disconnect device are located on the bottom of thespeaker, accessible through a hole in the granite base.2. The disconnect device is the power cord, detachable at either the speakeror the wall.3. The power cord must be disconnected from the speaker before servicing.Please Inspect For Shipping DamageEach loudspeaker leaves our plant in perfect condition. Any visible orconcealed damage most likely occurred in handling after it left our plant andshould be reported at once to your Definitive dealer or the delivery company thatdelivered your loudspeaker. Please unpack your system carefully. Save all cartonsand packing materials in case you move or need to ship your system. Record theserial number found on the back of the Mythos ST in the appropriate place on yourwarranty card, answer all questions and send it in.Unpacking Your Mythos STs3