Defy Automaid 600 Owner's Manual

Also see for Automaid 600 electronic: Owner's manual Owner's manual Owner's manual Owner's manual Product catalog

Contents

Defy Automaid 600 Owner's Manual Manual pdf 3 page image

Page 3Levelling1. The machine must stand firmly on the floor. Any instability will negatively affectits performance.2. The machine has two adjustable feet at the front.3. To level the machine, loosen the plastic lock nuts on the adjustable feet.4. Rotate the feet until the machine stands firm and level.5. Tighten the lock nuts firmly.6. Caution : Never remove the lock nuts and feet from the machine.NOT LEVELLED NOT LOCKED LEVELLEDAND LOCKEDConnecting to the cold water supply1. The water supply should deliver 8 to 80 litres per minute.2. Sealing washers are supplied and these should be fitted at ei-ther end of the inlet hose3. Secure the angled end of the inlet hose to the water inlet atthe rear of the machine and the straight end to a 3/4 inchBSP cold water tap.4. Tighten both connections, open the tap and check for leaks.5. We recommend that the tap be closed when the machine isnot in use.Water drainageDraining into a dedicated outlet pipe (A)1. The outlet pipe must have an inside diameter of atleast 40 mm.2. The end of the pipe must be positioned between400 mm. and 1000 mm. above floor level.3. Secure the hooked end of the drain hose into theoutlet pipe.Draining into a sink or bath (B)1. The drain hose may be hooked over the edge of asink or bath in such a way that the end can not beimmersed in the collected waste water.2. The outlet end of the hose must be between 40 cm. and 100 cm. above floor level.3. Please note: The outlet hose must be kept free of kinks or restrictions as these willhinder the operation of the machineFLOORAAB40100