7EN3 InstallationRefer to the nearest AuthorisedService Agent for installation of yourproduct. To make the product readyfor use, make sure that the electricity,tap water supply and water drainagesystems are appropriate beforecalling the Authorised ServiceAgent. If they are not, call a qualifiedtechnician and plumber to have anynecessary arrangements carried out.C Preparation of the location andelectrical, tap water and wastewater installations at the place ofinstallation is under customer'sresponsibility.B Installation and electricalconnections must be carried outby the Authorised Service Agent.Manufacturer shall not be heldliable for damages that may arisefrom procedures carried out byunauthorised persons.B Prior to installation, visually checkif the product has any defects onit. If so, do not have it installed.Damaged products cause risks foryour safety.A Make sure that the water inletand discharge hoses are notfolded, pinched or crushed whilepushing the product into its placeafter installation or cleaningprocedures.When placing the product, payattention not to damage the floor,walls, piping, etc. Do not hold theproduct from its door or panel tomove it.Appropriate installationlocation· Place the product on a solid andflat floor that has sufficient loadcarrying capacity! The productmust be installed on a flat surfacein order for the door to be closedcomfortably and securely.· Do not install the product atplaces where temperature mayfall below 0ºC.· Place the product at least 1 cmaway from the edges of otherfurniture.· Place the product on a rigid floor.Do not place it on a long pile rugor similar surfaces.A Do not place the product on thepower cable.· Make sure that you select alocation that will allow you toload and unload the dishes in afast and comfortable manner.· Install the product in a place closeto the tap and the drain hole.Select the installation locationby considering that it will not bechanged after the connectionsare made.Connecting water supplyC We recommend attaching a filteron the house/apartment supplywater inlet to protect the machinefrom damages that may arisefrom impurities (sand, dirt, rust,etc.) coming from the urban watersupply system or from your ownwater system as well as to preventcomplaints such as yellowing or