LATCH & END WHEELS.... Latch & End Wheel CylindersSWING ARM CIRCUIT.................. Power-fold CylindersCTR WHEEL & FLOAT.... Hitch & Center Wheel Cylinders321ABConnect HydraulicsOpening into Field Position143376 v1.1(Refer to operators manual for complete safety and operation info.)• Check for missing, worn or damaged parts.• Working points & pins• Hydraulic Connections & Hoses• Hubs & SpindlesMaintenance(Check Machine Daily)QUICK-START GUIDE*for LRX LANDROLLERS* Refer to operators manual for complete safety and operation info.TOBE ELIGIBLEFORYOUMUSTREGISTERWARRANTYREMEMBER! You must complete ProductRegistration to be eligible for Warranty.337897) Remove the RedTransport Pin from thefloat hitch and secureit in storage position.8) Open the HydraulicBall Valve.9) Retract the Hitch Cylinderto place the Landroller into Float Position.33 36 66) Retract the Center Frame Cylinders to raise the centerframe wheels (lowering the center section to the ground).10) The LRX Landroller should now be in the proper positionfor field use. Read manual for further information.2442244) Extend the Power-fold Cylinders to fully open thewings. Ensure the swing-arm shafts properly latch intoplace.5) IMPORTANT:Retract thePOWER-FOLDCylindersRemember to retractthe Power-foldCylinders back intothe fully closed positionbefore use.22251) Drive the LRX Landroller onto an area of level groundlarge enough to open the wings. Ensure the Landroller ispositioned straight behind the tractor.2313) Activate the End WheelCylinders to completelyraise the end wheels andlower the ends of thedrums to the ground.12) Remove the four Red Transport Bars from the End Wheel& Center Wheel cylinders. Place the transport bars ontothe frame mounted storage brackets and secure with thelock-pins.Note: You may need to activate (extend) thehydraulic cylinders slightly to allow easierremoval of the cylinder Transport Bars.