Degelman PRO-TILL 14 Operator's & Parts Manual

Also see for PRO-TILL 14: Quick start guide

Contents

Degelman PRO-TILL 14 Operator's & Parts Manual Manual pdf 12 page image

-6-143387 - PRO-TILL 14|17|20 (02-April-2019)2 233Transport to Field Position OverviewTRANSPORT TO FIELD POSITIONB. Slightly extend the Transport Cylinder (#3) justenough to remove the weight of wings off from thewing transport carriers (approximately 1"). Do notlift more than needed.IMPORTANT: DO NOT fully extend the transportcylinders at this point. Follow proper procedures toprevent possible equipment damage or failure.D. After fully opening the wings,extend the Transport Cylinder(#3) to completely lowerthe Pro-Till rear framesections to the ground.A. On level ground, position thePro-Till so it is straight in-linebehind the tractor.FOLLOW PROCEDURE BELOW:C. Extend the Wing Cylinders (#2)to fully open the wingsbehind the machine.E. Place both the Transport Cylinder (#3) and theWing Cylinders (#2) into the FLOAT position beforeoperation.IMPORTANT:The Transport & Wing CylindersMUST both be in the "FLOAT"position in order for the Pro-Tillto properly contour the groundand to avoid possible cylinderor equipment damage.3231”NEVER LIFT WINGS!Unfold using the Wing Cylinders (2),then lower all rear sections usingthe Transport Cylinder (3).XX