Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Deister electronic LogIdent UDL500 Wiring & Installation Instructions

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Contents
  1. Table Of Contents
  2. Technical Data
  3. Connectors
  4. Pin assignment UDL500
  5. UDL500: Control digital output via hardware trigger
  6. UDL500: Control digital output via software trigger
  7. RS485 interface
  8. Mechanical dimensions
  9. Transmission protocol
  10. Extended mast holding device LRM2
  11. Wall mounting with link holder LRM1
  12. Function principle and environmental influences
  13. Radiation pattern of the transmitting antenna
  14. Configuration software
  15. Configuration
  16. Parameters
  17. Frequency Setup
  18. Mode Control
  19. Trigger
  20. Selection Settings
  21. Selection Mask
  22. Prog data
  23. Portal application with DCU1 Data Control Unit
  24. Accessories of the UHF product family
  25. Regulatory Notices
  26. FCC Notice
Deister electronic LogIdent UDL500 Wiring & Installation Instructions Manual pdf 22 page image
7.3 ParametersFor a detailed description of the configuration parameters please refer to the document“UDL/UDK deBus protocol”. Application notes regarding the configuration settings can befound at “deister RFID Portal“ (www.deister.com – deister RFID Portal). If transponder typeEPC class1 gen2 is used, the configuration parameters refer to the specification ofEPCglobal™ (EPCglobal™, Class 1 Generation 2 UHF Air Interface Protocol Standard).7.3.1 Basic SetupOperating ModeSingle reader for operating of a single reading-/writing devicePortal mode for operating several reading-/writing devices using a dataconcentration unit (DCU1)Trigger mode for operating of a reading-/writing device using the trigger modeAnticollisionsingle tag in field operation mode for reading transponder data, in case there isonly one tag in the field (anticollision deactivated)handle multiple tags operation mode for reading transponder data, in case there ismore than one tag in the field (anticollision activated)Regulatory SettingsSelection of the regulation used by reader ETSI 302 208 (EU)ETSI 300 220 (EU), optionalFCC Part 15 (US), optionalTransponder Typeselection of transponder type, which has to be read/writtenRead contentSerial number reading the EPCRead mode for reading transponder dataWrite mode for writing a transponder22 deister electronic GmbH 30890 Barsinghausen Germany V17/01/08Wiring & Installation Instructions UDL500
/ 36
This manual is suitable for:
LogIdent UDL500
Manuals database logo
manualsdatabase
Your AI-powered manual search engine