DekTec DTE-3114 User Manual
                                                  | |
Contents
| 
DTE-3114 – Networked Quad QAM ModulatorUSER MANUAL14DTE-3114, so one of them should be deleted. To remove the link-local route through192.168.100.28, use the following command:route DELETE 169.254.0.0 MASK 255.255.0.0 192.168.100.28This will result in a correct routing table.2.6 Failsafe modeThe DTE-3114 supports a special “failsafe” mode to enable recovery from an erroneousconfiguration. In failsafe mode the unit has no modulation functionality and the user can onlyconfigure the IP address and load new firmware.Failsafe mode is entered in the following cases: A firmware upgrade of the DTE-3114 has failed. The reset button is kept pressed while the DTE-3114 powers up. The reset button is kept pressed for at least 3 seconds.In the latter two cases, the DTE-3114 will obtain an IP address through DHCP, even if a static IPaddress was configured.In failsafe mode just 3 tabs are enabled in the web interface: Network Settings. This allows for changing the IP-address settings. Application Switcher. The operational application can be selected. In the current version of theDTE-3114 just one application is present, so there is nothing to chose. Firmware Upgrade. See section 3.5 for more information.2.7 Factory defaults2.7.1 SMPTE SettingsAddressing mode multicastIP addresses 224.1.1.1, 224.1.1.2,224.1.1.3, 224.1.1.4Ports 8000, 8010, 8020, 8030FEC decoding enabledIP-to-RF delay 100ms2.7.2 Modulator SettingsChannel enable disabledFrequency 600, 608, 616, 624MhzModulation DVB-CQAM mode 256-QAMSpectral inversion disabledInterleaver mode I=128, J=1RF level -20dBm |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine