5. Mountinga. Note: SpaEclipse™ Dual Voltage models are equipped with a voltageselector switch on the back of the unit. Set this switch to the appropriate volt-age (as indicated on the switch) prior to installation. Once the proper voltage hasbeen selected (comes preset at 230V), cover the switch with the label provided toprevent tampering (refer to Figure 3).b. Mount the Ozone Generator as high as possible within the spa’s protectedequipment area.c. Screws are provided for mounting but may not be appropriate for allsurfaces. Substitute proper mounting hardware as required.d. For ZO-300, ZO-302 and ZO-301: Attach the Metal Spring Clips to themounting surface so that the openings are aligned. Spread the clips so they areapproximately 2 inches from each end. Insert one side of the Ozone Generatorfirst, then rotate the unit to snap in place.e. For all other models, use the mounting features provided on the OzoneGenerator.6. Plumbing - Vacuum System (refer to Figure 4)a. Most spas are factory equipped with an ozone injector or vacuum port,like the one shown in Figure 3. Review your Spa’s Installation Manual to identifythe correct ozone connection location.b. If the spa is not equipped with a vacuum source, DEL Ozone provides awide range of optional installation kits. Contact DEL Customer Service for assis-tance at 800.676.1335 x 249.7. Plumbing - Ozone Generator (refer to Figure 4)a. Connect the PVC ozone tubing provided to the hose barb on the OzoneGenerator.b. Slide hose clamps onto the tubing and run the tubing to the vacuum source.i. If the Ozone Generator is mounted above the water line, tubingmay be run directly to the vacuum source.ii. If Ozone Generator is mounted below the water line, run tubing toa point above the water line and back down to the vacuum source.Secure Tubing in this position.Figure 3Switch Cover Label Applicationfor SpaEclipse™ Dual VoltageVoltage SelectorCover Label6