Delfield 4400 Series Installation & Operation Manual

Also see for 4427N: Service and installation manual Brochure & specs Installation & operation manual Installation & operation manual Original instructions

Contents

Delfield 4400 Series Installation & Operation Manual Manual pdf 17 page image

17Compact Refrigeratorsstyle and can be pulled out of the groove in the door andnew gaskets can be “pressed” back into place.Doors/HingesOver time and with heavy use the door hinges may becomeloose. If it is noticed that the door is beginning to sag, it maybe necessary to tighten the screws that mount the hingebrackets to the frame of the cabinet. If the doors are looseor sagging, this can cause the hinge to pull out of the framewhich may damage both the doors and the door hinges.In some cases this may require repair by a qualified serviceagent or maintenance personnel.Drain MaintenanceEach cabinet has a drain located inside which removes thecondensation from the evaporator coil and evaporates itat an external condensate evaporator pan. Each drain canbecome loose or disconnected from moving or bumpingthe drain. If you notice excessive water accumulation on theinside of the cabinet, be sure the drain tube is connected fromthe evaporator housing to the condensate evaporator drainpan. If water has collected underneath the cabinet, check thecondensate evaporator drain tube to be sure it is still locatedinside the drain pan. Leveling the cabinet is important as itis designed to drain properly when on a level surface. If yourfloor is not level this can also cause drain problems. Be sureall drain lines are free of obstructions. Typically, food productis found blocking drain lines causing water to back up andoverflow the drain pans.Drawer MaintenanceDrawer Assembly CleaningThe drawer assembly is designed to be cleaned easily. Both drawerand tracks are removable without tools. The drawer tracks aredishwasher safe or can be cleaned in a sink with detergents anda soft bristle brush. Drawers and tracks should be cleaned on aweekly basis.Remove DrawersPull the drawer box out until it stops. Lift up on the drawer frontand pull the drawer box completely out. Using a soft bristle brush,clean the track on the bottom of the drawer box. When finished,it should be wiped clean of all food and debris.TracksThe drawer box assembly must be removed. Pull the drawertracks out until they hit a stop. Locate blue safety clips towardsthe back of each drawer track. Blue safety clips have a tab on thetop. Push the tab back until it clicks. Lift up and pull the drawertracks all the way out of thedrawer cage. The drawertracks are dishwasher safeor can be cleaned in a sinkwith detergents and a softbristle brush. Drawers andtracks should be cleanedon a weekly basis. Using a soft bristle brush, wash the track makingsure each roller is thoroughly cleaned. The drawer cage should becleaned with a soft bristle brush, removing any food and debrisgathered on the bottom ledge. Once it’s cleaned thoroughly witha soft bristle brush, wipe remaining debris clean with a soft towel.ReassemblyPush the drawer tracks into the drawer cage. The blue safetyclip must remain pushed towards the back. Lift up and slide thedrawer track all the way into the drawer cage. The blue safety clipwill lock in place automatically. Once all tracks are replaced, insertthe drawer box. Rest the drawer box bottom track on the fronttrack roller. Then push the drawer back in place SLOWLY. When thedrawer box is about half way in you will hit a STOP. You must liftthe front of the drawer up approximately ½” (1.3cm) to continueinward. Clean tracks as often as possible. The cleaner the tracksare the better they will operate.Fluorescent Light Bulb ReplacementDelfield recommends that fluorescent light bulbs be recycledrather than disposed of.tab on top ofblue safety clipMaintenance, continued