Dell 1420X User Manual
                                                               | |
Contents
| 
Using Your Projector 153Using Your ProjectorTurning Your Projector OnNOTE: Turn on the projector before you turn on the source (computer, DVDplayer, etc.). The Power button light blinks blue until pressed.1 Remove the lens cap.2 Connect the power cord and appropriate signal cables. For information aboutconnecting the projector, see "Connecting Your Projector" on page 9.3 Press the Power button (see "Using the Control Panel" on page 20 to locate thePower button).4 Turn on your source (computer, DVD player, etc.)5 Connect your source to the projector using the appropriate cable. See"Connecting Your Projector" on page 9 for instructions to connect your source tothe projector.6 By default, the input source of the projector is set to VGA-A. Change the inputsource of the projector if necessary.7 If you have multiple sources connected to the projector, press the Source buttonon the remote control or control panel to select the desired source. See "Using theControl Panel" on page 20 and "Using the Remote Control" on page 22 to locatethe Source button.Turning Your Projector OffCAUTION: Unplug the projector after properly shutting down as explained inthe following procedure.1 Press the Power button.NOTE: The "Press Power Button to Turn off Projector" message willappear on the screen. The message disappears after 5 seconds or you canpress the Menu button to clear it.2 Press the Power button again. The cooling fans continue to operate for 60seconds. |
Related manuals for Dell 1420X
manualsdatabase
Your AI-powered manual search engine