Se t ting Up for L ocal Pri nti ng 33Using Windows NT With a Parallel CableNOTE: You need administrative access to install printer drivers on your computer.1 Insert the Drivers and Utilities CD.2 When the Drivers and Utilities CD screen appears, click Personal Installation - Installthe printer for use on this computer only to install the additional software for yourprinter.3 Select your printer from the drop-down box.4 Select Typical Installation (recommended), and then click Install.When all of the files are installed on your computer, the Congratulations screenappears.5 Click Finish to exit the Drivers and Utilities CD screen.Using Windows Me With a USB or Parallel CableNOTE: Depending on the software and printers already installed on your computer, your screensmay vary from those in the instructions.If you are connecting the printer using a USB cable, you must install both a USB port driverand a custom print driver.When you attached the cable and turned on the printer and computer, the Add NewHardware Wizard screen appeared on your computer screen.1 Insert the Drivers and Utilities CD.If you are using a USB cable, the Wizard automatically searches for the USB driver onthe CD and installs it.If you are using a parallel cable, skip to step 3.2 After the USB port driver is found, click Finish.3 Select Automatic search for the best driver (recommended), and then click Next.The wizard searches for a printer driver.4 Select D:\Drivers\Print\Win_9xme\ language folder>\dkaag2da.inf from the list on the screen (where D is the drive letter of your CD),and then click OK.5 Click Next to install the printer driver.6 Click Next to complete installation.