52 Using Your Projector2. Press the button to enter IP Address, Subnet Mask, Gateway, orDNS to set the value. (The selected option is highlighted in blue)a Use and buttons to select the option.b Use and buttons to set the value.c After the setup is complete, press the button to exit.3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,select Store and press button to store the settings.4. If you select Store without pressing the Enter button, the system willkeep the original settings.R ESET —Press to reset wireless configuration.M ENU S ETTINGS —Select and press to activate the menu settings. The menusettings consists of the following options:MENU P OSITION —Allows you to change the position of the OSD menu onthe screen.MENU TIMEOUT —Allows you to adjust the time for an OSD timeout. Bydefault, the OSD disappears after 20 seconds of non-activity.MENU TRANSPARENCY —Select to change the transparency level of the OSDbackground.MENU L OCK —Select On to enable the Menu Lock and hide the OSDmenu. Select Off to disable the Menu Lock. If you want to disable theMenu Lock function and have the OSD disappear, press the Menu buttonon the control panel or remote control for 15 seconds, and then disable thefunction.PASSWORD—When Password Protect is enabled, a Password Protect screenrequesting you to enter a password will be displayed when the power plug isinserted into the electrical output and the power for the projector is firstturned on. By default, this function is disabled. You can enable this featureby selecting Enabled. If the password has been set before, key in the
