Hardware Installation and Configuration 37Figure 3-11. Removing the PERC 5/i AdapterNOTE: See the Hardware Owner's Manual for information on removing the PERC 5/i from the system.Removing the DIMM from a PERC 5/i CardThis section describes how to remove the memory module on a PERC 5/i Adapter or PERC 5/i that iscurrently installed in a system.NOTE: PERC 5 cards support DELL-qualified 256-MB DDRII 400MHz ECC-registered DIMMs with x16 DRAMcomponents. Installing unsupported memory causes the system to hang at POST.1 Perform a controlled shutdown on the system in which the PERC 5/i is installed and remove thePERC 5/i from the system by following the instructions detailed in the section "Removing thePERC 5/i Adapter" on page 35.CAUTION: Running a system without the system cover installed can cause damage due to improper cooling.2 Remove the DIMM by pressing down on the tabs at each edge of the DIMM connector and lifting theDIMM off the controller.NOTE: The location of the PERC 5/i varies from system to system. See the Hardware Owner’s Manualthat shipped with the system for specific information on the location of the PERC 5/i.PERC 5/i Adaptermemory modulebracket screwDell_PERC5_UG.book Page 37 Tuesday, February 13, 2007 6:02 PM
