Dell AND SVUA Product Information Manual

Also see for AMP01: Getting started guide Getting started guide Getting started Getting started

Contents

Dell AND SVUA Product Information Manual Manual pdf 12 page image

10 Product Information GuideSAFETY: When Working Inside Your SystemBefore you remove the system covers, perform the following steps in the sequence indicated.CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the componentsinside the system.CAUTION: The memory modules can become extremely hot during operation. Allow the modules sufficient time to coolbefore handling.NOTICE: To help avoid possible damage to the system board, wait 5 seconds after turning off the system before removinga component from the system board or disconnecting a peripheral device.1 Turn off the system and any devices.2 Ground yourself by touching an unpainted metal surface on the chassis before touching anything inside the system.3 While you work, periodically touch an unpainted metal surface on the chassis to dissipate any static electricity that might harminternal components.4 Disconnect your system and devices from their power sources. To reduce the potential of personal injury or shock, disconnectany telecommunication lines from the system.In addition, take note of these safety guidelines when appropriate:• When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable itself. Some cables have aconnector with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before disconnecting thecable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connecta cable, make sure that both connectors are correctly oriented and aligned.• Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or byits metal mounting bracket. Hold a component such as a microprocessor chip by its edges, not by its pins.SAFETY: Protecting Against Electrostatic DischargeElectrostatic discharge (ESD) events can harm electronic components inside your computer. Under certain conditions, ESD maybuild up on your body or an object, such as a peripheral, and then discharge into another object, such as your computer. To preventESD damage, you should discharge static electricity from your body before you interact with any of your computer’s internalelectronic components, such as a memory module. You can protect against ESD by touching a metal grounded object (such as anunpainted metal surface on your computer’s I/O panel) before you interact with anything electronic. When connecting aperipheral (including handheld digital assistants) to your computer, you should always ground both yourself and the peripheralbefore connecting it to the computer. In addition, as you work inside the computer, periodically touch an I/O connector to removeany static charge your body may have accumulated.You can also take the following steps to prevent damage from electrostatic discharge:• When unpacking a static-sensitive component from its shipping carton, do not remove the component from the antistaticpacking material until you are ready to install the component. Just before unwrapping the antistatic package, be sure todischarge static electricity from your body.• When transporting a sensitive component, first place it in an antistatic container or packaging.• Handle all electrostatic sensitive components in a static-safe area. If possible, use antistatic floor pads and work bench pads.book.book Page 10 Tuesday, January 9, 2007 11:43 AM