Figure 9. C1048P Port Numbering1. C1048P 10/100/1000BASE-T ports 1-48Next StepsAfter you complete the initial C1048P provisioning, you can configure L2 software features on theC1048P from the C9010 console CLI, including LLDP, 802.1x, LACP, loop detection and BPDU guard. Noother L2 protocols are supported. IP address and L3 protocol configuration on C1048P ports are notsupported. For detailed information, see the Dell Networking Configuration Guide for C9000 SeriesSwitches.When the C1048P is online, you can enter the connect pe pe-id command on the C9010 console toremotely log in to the C1048P CLI. To log in, enter the user name peadmin and the password calvin.After logging in, you can enter show and stack renumbering commands on the C1048P.To move through command modes in the C1048P CLI, see the Command Modes section in the DellNetworking C9010 Getting Started Guide.22 Configuring the Software

Dell C1048P Getting Started Manual