Removing and Replacing Parts : Dell Latitude C600/C500 Series Service ManualRemoving the 12.1-Inch Display Assembly BezelNOTICE: Disconnect the computer and any attached devices from electrical outlets, and removeany installed batteries.NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching anunpainted metal surface on the computer.NOTICE: Read "Preparing to Work Inside the Computer" before performing the followingprocedure.1. Remove the hard drive.2. Remove the display assembly.3. Use the scribe to pry the six rubber screw covers out of the screw holes located on the bezel on thefront of the display assembly.4. Remove the six M2.5 x 5-mm screws located on the bezel on the front of the display assembly.NOTICE: To avoid damage to the bezel, do not bend the bezel while separating it from the display-assembly top cover.5. Use a plastic scribe to carefully separate the bezel from thedisplay-assembly top cover.Removing the 12.1-Inch Display PanelNOTICE: Disconnect the computer and any attached devices from electrical outlets, and removeany installed batteries.NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching anunpainted metal surface on the computer.1. Remove the hard drive.2. Remove the display assembly.3. Remove the display assembly bezel.4. Remove the hinge covers.5. Remove the four M3 x 3-mm screws on the front of the display panel that secure the display panelto the support bracket.file:///F|/Service%20Manuals/Dell/Latitude/c500-600/remove.htm (18 of 40) [2/28/2004 7:53:33 AM]