Dell D17S005 Owner's Manual

Also see for D17S: Setup and specifications Service manual Service manual Service manual Service manual

Steps1. Peel off the protection film on the thermal pad and align and adhere the thermal pad on the M.2 2230 solid-state drive sloton the system board.NOTE: The thermal pad is re-usable. The thermal pad is pre-installed on systems shipped with solid-state drive. If thesolid-state drive is purchased separately, the thermal pad is not bundled with the solid-state drive kit and is to bepurchased separately.2. Peel off the protection mylar on the thermal pad.3. Align the notch on the M.2230 solid-state drive with the tab on the M.2 card slot on the system board.4. Slide the M.2230 solid-state drive into the M.2 card slot on the system board.5. Replace the screw (M2x3.5) to secure the M.2230 solid-state drive to the system board.Next steps1. Install the disk-drive cage.2. Install the 3.5-inch hard drive if applicable.3. Install the 2.5-inch hard drive if applicable.4. Install the front bezel.5. Install the side cover.6. Follow the procedure in After working inside your computer.58 Entfernen und Installieren von vom Kunden austauschbaren Einheiten (CRUs)