16ERROR MESSAGE AND POSSIBLE SOLUTIONNO SIGNAL1� Check that the signal-cable is properly connected� If the connector is loose, tightenthe connector’s screws�2� Check the signal-cable’s connection pins for damage�INPUT NOT SUPPORTEDYour computer has been set to unsuitable display mode� Set the computer to displaymode given in the table on page 18�

for your safety

special notes on lcd monitors

before you operate the monitor

controls and connectors

adjusting the viewing angle

OPERATING INSTRUCTIONS

FRONT PANEL CONTROL

HOW TO ADJUST A SETTING

ADJUSTING THE PICTURE

PLUG AND PLAY

TROUBLESHOOTING

ERROR MESSAGE AND POSSIBLE SOLUTION

APPENDIX

FACTORY PRESET TIMING TABLE

CONNECTOR PIN ASSIGNMENT

Dell D2216H User Manual

D2216H


Contents Table Of Contents for your safety special notes on lcd monitors before you operate the monitor controls and connectors adjusting the viewing angle OPERATING INSTRUCTIONS FRONT PANEL CONTROL HOW TO ADJUST A SETTING ADJUSTING THE PICTURE PLUG AND PLAY TROUBLESHOOTING ERROR MESSAGE AND POSSIBLE SOLUTION APPENDIX FACTORY PRESET TIMING TABLE CONNECTOR PIN ASSIGNMENT	16ERROR MESSAGE AND POSSIBLE SOLUTIONNO SIGNAL1� Check that the signal-cable is properly connected� If the connector is loose, tightenthe connector’s screws�2� Check the signal-cable’s connection pins for damage�INPUT NOT SUPPORTEDYour computer has been set to unsuitable display mode� Set the computer to displaymode given in the table on page 18� Previous Next / 19