Figure 6 Slide the system into the cabinetInstall the bezelProcedure1. Align and insert the right end of the bezel onto the system.2. Press the release button and fit the left end of the bezel onto the system.3. Lock the bezel by using the key.Hardware Installation Guide10 Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide

Dell DP4400 Hardware Installation Manual

EMC Integrated Data Protection Appliance DP4400

Chapter 1 Prepare for assembly replacement

Hardware replacement overview

Shut down the IDPA

Troubleshooting shutdown of the DP4400

Chapter 2 Remove and replace assemblies

Safety instructions

Remove and replace power supply

Remove and replace a power supply

Hard drive replacement overview

Identifying a failed disk from the ACM

Remove the front bezel to access front panel hard drives

Install the hard drives

Install the front bezel

Verifying successful disk replacement from the ACM

Remove internal hard drives

Remove hard drive carrier from the mid hard drive tray

Replace a hard drive in the mid hard drive tray

Install the system cover

Slide the system into the cabinet

Remove fans

Extend the system from the cabinet

Remove the cooling fan

Install the cooling fan

DIMM remove and replace

Disconnect the power cords and I/O cables

Remove mid hard drive tray

Remove the memory module

Install the mid hard drive tray

Connect the I/O cables and power cords

M2 memory remove and replace

Replace an M.2 module

Remove and replace NIC cards

NIC indicator codes

Remove the rear hard drive cage

Install the network daughter card

Install the rear hard drive cage

Verifying successful NIC replacement from the ACM

Document references for IDPA

Service video resources