Dell DR4100 Best Practices Manual

Also see for PowerVault DR4100: Administrator's guide Reference guide Release note Manual Manual

Contents

28 DR4100 Best Practice Guide | April 20141. Set bond0 to 1GB using the following command:network --factory_reset [--auto_bonding_speed <1G|10G>]2. Use the following command to view the new configuration:network --show3. Create a bond for the 2x 10GB interfaces using the following command:Exampleadministrator@DR1 > network -- factory_reset –auto_bonding_speed 1GWarning: This will stop all system operation and will reset the network configuration tofactory settings and will require a system robbon. Existing configuration will be lost.One or more of these interfaces 'eth0,eth1' are in use by an application.Factory reset cannot be done while interfaces are in use by an application.Factory reset will remove all application interface settings.Password required to proceed. Please enter the administrator password :administrator@DR1 > System --rebootExampleadministrator@DR1 > network -- showAutomatic bonding speed: 1GDevice : bond0Enabled : yesLink : yesBoot protocol : dhcpIP Addr : 10.250.242.173Netmask : 255.255.252.0Gateway : 10.250.240.1MAC Addr : BC:30:5B:F3:22:74MTU : 9000Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"Member Interfaces : eth0,eth1eth0 MAC : BC:30:5B:F3:22:74eth0 Max Speed :1000baseT/Fulleth0 Speed :1000Mb/seth0 Duplex :Fulleth1 MAC : BC:30:5B:F3:22:75eth1 Max Speed :1000baseT/Fulleth1 Speed :1000Mb/seth1 Duplex :Full