For Data Domain HA systems, SSH keys created on the active node take 30 secondsto one minute to propagate to the standby node.Accepting the End User License Agreement (EULA)The first time you log in to a Data Domain system, the End User License Agreement(EULA) is displayed.At the end of the EULA, you are prompted to accept it:Press any key then hit enter to acknowledge the receipt of EULAinformationNoteThe EULAmust be accepted by a customer. A Data Domain representative shouldnotaccept this agreement. If a customer is not present, press Ctrl-C to exit from theEULA acceptance screen and continue the installation.The customer can later enter the following to redisplay the EULA and accept it:system show eulaRun the configuration wizardThe CLI configuration wizard starts automatically the first time the system boots. Thewizard prompts you through a series of questions that provide just enough informationfor initial system configuration and basic network connectivity.NoteYou can initiate the CLI configuration wizard manually by entering the config setupcommand.Configuring the networkProcedure1. Enter yes to configure the system for network connectivity.Network ConfigurationConfigure Network at this time (yes|no) [no]:yes2. Enter yes to configure DHCP (Dynamic Host Configuration Protocol) to obtainnetwork parameters (such as, the host name, domain name, and IP addresses)dynamically from a DHCP server. Or enter no to configure the parametersmanually.Use DHCPUse DHCP for hostname, domainname, default gatewayand DNS servers? (At least one interface needs tobe configured using DHCP) (yes|no|?)3. Enter a fully qualified domain name (FQDN) for the host name; for example,str01.yourcompany.com. Or accept the host name, if the system was able todiscover it.Enter the hostname for this system(fully-qualified domain name)[]:Configure System For Use88 Data Domain DD9500 and DD9800 Systems 6.1 Hardware Overview and Installation Guide
