Back to Contents PageRemoving and Installing PartsDell™ Dimension™ 3000 Systems Service ManualMemoryYou can increase your computer memory by installing memory modules on the system board. For information on the type of memory supported by yourcomputer, see Specifications.DDR Memory OverviewDDR memory modules should be installed in pairs of matched memory size. This means that if you purchased your computer with 128 MB of memory installedand you want to add another 128 MB of memory, you should install it in the appropriate connector. If the DDR memory modules are not installed in matchedpairs, the computer will continue to operate, but with a slight reduction in performance.The recommended memory configurations are:l Install a pair of matched memory modules in connectors DIMM3 and DIMM4.l Do not install ECC memory modules.l If you install a mixed pair PC2700 (DDR 333-MHz) and PC3200 (DDR 400-MHz) memory, the modules function at the slowest speed installed.l Be sure to install a single memory module in DIMM3 or the connector closest to the processor before you install modules in the other connector.Memory Installation GuidelinesInstalling Memory1. Shut down the computer through the Start menuMemoryCardsFront PanelDrivesHard DriveFloppy DriveCD/DVD DriveProcessorFan AssemblySystem BoardPower SupplyBatteryNOTE: DDR 333 memory operates at 320 MHz when used with an 800-MHz front-side bus.NOTE: Always install DDR memory modules in the order indicated on the system board.NOTE: Your computer has two memory slots labeled DIMM3 and DIMM4.NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules thatyou may have, even if you purchased the new modules from Dell. You should install your new memory modules in connectors DIMM3 and DIMM4. Ifpossible, do not pair an original memory module with a new memory module. Otherwise, your computer may not function at optimal performance.NOTE: Memory purchased from Dell is covered under your computer warranty.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.