|
System Setup Options or Scrolls through help information. Enters the selected field's pop-up options menu.spacebar, <=> or <-> In the selected field's pop-up options menu, cycles through the options in a field. Exits system setup without restarting the computer and returns the computer to the boot routine. Exits system setup and restarts the computer, implementing any changes you have made. Resets the selected option to the default setting. Restores all system settings to the default configuration.NOTE: Depending on your computer and installed devices, the items listed in this section may or may not appear.Drive ConfigurationDiskette DriveAIdentifies the floppy drive attached to the DSKT connector on the system board. With the standard cabling configuration, Diskette DriveA (the boot floppy drive) is the 3.5-inch floppy drive installed in the top externally accessible drive bay. The two options are 3.5 Inch,1.44 MB and Not Installed.Tape drives are not reflected in the Diskette Drive A option. For example, if a single floppy drive and a tape drive are attached to thefloppy drive interface cable, set Diskette Drive A to 3.5 Inch, 1.44 MB.SATA PrimaryDriveIdentifies the serial ATA hard drive attached to the SATA1 connector on the system board.SATASecondaryDriveIdentifies the serial ATA hard drive attached to the SATA2 connector on the system board (not available on the small form-factorcomputer).Primary Drive0Identifies the IDE hard drive attached to the IDE1 connector on the system board.Primary Drive1Identifies the IDE device attached to the IDE2 connector on the system board.SecondaryDrive 0Identifies the device that is cabled with the drive on the IDE1 data cable.SecondaryDrive 1Identifies the device that is cabled with the device on the IDE2 data cable.IDE DriveUDMASets the mode for all installed hard drives.NOTE: You must have an IDE device connected to the primary IDE interface if you have an IDE device connected to the secondary IDEinterface.If you have a problem, see "Hard Drive Problems" in your Owner's Manual.Hard-Disk Drive SequenceIf you insert a boot device and restart, this option appears in the system setup menu.System BIOS boot deviceUSB Device To boot from a USB memory device, select the USB device and move it so it becomes the first device in the list.Boot SequenceNormal (This option is available only for the current boot process.) The computer attempts to boot from the sequence of devices specified in systemsetup.DisketteDriveThe computer attempts to boot from the floppy drive. If the floppy disk in the drive is not bootable, or if no floppy disk is in the drive, thecomputer generates an error message.Hard Drive The computer attempts to boot from the primary hard drive. If no operating system is on the drive, the computer generates an errormessage.CD Drive The computer attempts to boot from the CD drive. If no CD is in the drive, or if no operating system is on the CD, the computer generates anerror message.PXE (This option is available only for the future boot process.) As the computer boots, it prompts the user to press . Pressing thiskey combination causes a menu to display that allows you to select a method for booting from a network server. If a boot routine is notavailable from the network server, the computer attempts to boot from the next device in the boot sequence list.USB FlashDeviceInsert the memory device into a USB port and restart the computer. When F12 = Boot Menu appears in the upper-right corner of the screen,press . The BIOS detects the device and adds the USB flash option to the boot menu.NOTE: To boot to a USB device, the device must be bootable. To ensure that your device is bootable, check the device documentation.Memory InformationIndicates amount of installed memory, computer memory speed, amount of video memory, size of the display cache, and channel mode (dual or single).Installed System Memory Displays the amount of installed system memory.System Memory Speed Displays the speed of your system memory.
|
