Dell Dimension 4600C Service Manual

Also see for Dimension 4600C: Quick setup guide Owner's manual

Back to Contents PageAGP CardYour Dell™ computer provides a connector for an AGP card.1. Shut down the computer through the Start menu.2. Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shutdown your computer, turn them off now.3. Disconnect any telephone or telecommunication lines from the computer.4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.5. Remove the computer stand, if it is attached.6. Open the computer cover.Removing an AGP Card1. Remove the filler bracket by raising the hinged lever and sliding the filler bracket up.2. Slide the card clip toward the front of the computer until the tab is out of the notch on the card.3. Pull the card up and out of the AGP connector.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Owner's Manual or Product InformationGuide.NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of thecomputer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.