Direct-Access FunctionsUsing the On-Screen Display (OSD) MenuAccessing the Menu System1. With the menu off, press the MENU button to open the OSD system and display the main features menu.2. Press the - and + buttons to move between the function icons. As you move from one icon to another, the function name is highlighted to reflect thefunction or group of functions (sub-menus) represented by that icon. See the table below for a complete list of all the functions available for the monitor.3. Press the MENU button once to activate the highlighted function. Press -/+ to select the desired parameter, press menu to enter the slidebarthen use the - and + buttons, according to the indicators on the menu, to make your changes.4. Press the MENU button once to return to the main menu to select another function or press the MENU button two or three times to exit from the OSD.IndicatorFunction Adjustment MethodAuto adjustment Use this button to activate automatic setup and adjustment. The following dialog will appear onscreen as the monitor self-adjusts to the current input:Auto Adjustment button allows the monitor to self-adjust to the incoming video signal. Afterusing 'Auto Adjustment', you can further tune your monitor by using the 'Pixel Clock' and 'Phase'controls in the OSD.Auto Adjustment in Progress...NOTE: Auto Adjust will not occur if you press the button while there are no active video inputsignals, or attached cablesBrightness/ContrastWith the menu off, press the button to display the 'Brightness' and 'Contrast' adjustmentmenu.The 'Brightness' function adjusts the luminance of the flat panel.Adjust 'Brightness' first, then adjust 'Contrast' only if further adjustment is necessary."+" increase 'brightness'" - "decrease 'brightness'The 'Contrast' function adjusts the degree of difference between darkness and lightness on thedisplay screen."+" increase the 'contrast'"-" decrease the 'contrast'A Function icons B Main Menu C Menu iconD Sub-Menu name E ResolutionIcon Menu Nameand Sub-menusDescription