Back to Contents PageSetting Up the MonitorDell™ E2211H/E2311H monitor User's GuideAttaching the StandConnecting the MonitorOrganizing the CablesAttaching the Soundbar (Optional)Removing the StandWall Mounting (Optional)Attaching the StandTo attach the monitor stand:1. Remove the cover and place the monitor on it.2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.3. Press the stand till it snaps into its place.Connecting Your MonitorTo connect your monitor to the computer:1. Turn off your computer and disconnect the power cable.2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of yourcomputer. Do not connect both cables on the same computer. Use both the cables only when they are connected to two different computers withappropriate video systems.Connecting the White DVI CableConnecting the Blue VGA CableNOTE: The stand is detached from monitor when it is shipped from the factory.NOTE: This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set upinstructions.WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.